Polycarbonate Sheets in a wide range of sizes and colours
Polycarbonate Sheets are predominantly used in the glazing and roofing industries. At PVC Cladding we stock Multiwall Polycarbonate in a wide range of sizes and colours, accompanied by a large selection of glazing bars and trims.
We also stock Solid Polycarbonate and Acrylic Sheets for glazing in balconies, stairwells and public areas. This section of our website also includes a large selection of Door Panel Blanks.
PLEASE NOTE - these products are delivered direct from the manufacturer and there is currently a short delay to shipments - lead times are anticipated to be approximately 3-7 days.
Multiwall Polycarbonate Sheets are generally used for conservatory and lean-to roofs. They are lightweight and strong, with excellent insulating properties.
At PVC Cladding we offer a large range of competitively priced pre-cut sheets but if required we can also cut sheets to your exact specifications.
Our Polycarbonate Glazing Bar options come in either timber supported or self-supported options, depending upon which best suits your particular installation and budget. We also offer a large range of edge finishing trims and eaves beams to enable the full construction of a completely finished roof from scratch.
Solid Polycarbonate Sheets are used most commonly in commercial glazing applications. They are virtually unbreakable, so are often installed in areas where either safety or potential vandalism is a key consideration.
Door Panel Blanks are used in the manufacture of PVC Doors and side infill panels by the double glazing industry. They come in a range of sizes and different shades of white.
What should I use for a conservatory roof or living room
We recommend that you use 25mm, 32mm or 35mm Polycarbonate Sheets for conservatory roof glazing. By using thicker polycarbonate glazing, this allows to gain optimum U values and insulation levels.
What type of polycarbonate sheets should I use in a greenhouse?
Most greenhouses use 4mm thick glazing – please call us to place an order.
What is the best glazing material so stop heat build-up
We recommend using our Solarguard sheet. This is an innovative polycarbonate with a grey metallic surface on Opal. It is designed to limit heat build-up within the conservatory/room and by deflecting solar radiation it can reduce solar heat gain through the roof by up to 50% compared to conventional material.
How do I cut Polycarbonate Sheets
Polycarbonate sheets can be cut with a circular saw (using a very fine blade) or a jig saw. If possible, it is better to cut a few sheets at a time to reduce vibration. Sheets can also be cut by hand using tin snips or a utility knife.
How Do I Clean Polycarbonate Sheets
We recommend using warm water with a mild household detergent. This should be sufficient to clean the sheets. Wipe off any remaining dirt with a soft cloth and wash again. NEVER use a solvent-based cleaner. AVOID using sponges or brushes that can scratch the surface of the sheet.
Which Side Up Should The Polycarbonate Sheets Be Installed
Polycarbonate Sheets should always be installed with the branded film facing up (outside).
Want some advice on how to install your polycarbonate sheets, or interested in finding out more about our product range, take a look at our guides & tips.