FloPlast Solvent Weld Waste Bend Swivel - 135 Degree x 32mm Grey

In stock
Only %1 left
Code
WS76G

Click or tap the image to open in fullscreen

FloPlast Solvent Weld Waste Bend Swivel - 135 Degree x 32mm Grey
FloPlast Solvent Weld Waste Bend Swivel - 135 Degree x 32mm Grey
More Information
Code WS76G
£0.72 £0.60 £0.86 Save 17%
Spend another £1500 to pay over time with Klarna

135 degree swivel bends are used to create a tight radius 45 degree change of direction in a waste pipe system. They are also often referred to as 45 degree M and F bends or spigot bends. They have a long tail that is usually inserted into the socket of another fitting.

This fitting is available in 32mm, 40mm and 50mm size options.

Our solvent weld waste is manufactured in the UK to BS EN 1455 and is kitemarked.

To make a solvent weld joint, first ensure that the outer wall of the pipe and the inner wall of the fitting are both clean and free from grit or swarf. Apply SC250 solvent cement to both surfaces. Push the pipe fully into the fitting and give it a twist to ensure that full contact has been made. Clean off any excess solvent with a damp cloth and leave for 5 minutes to set. The installation should be left for 12 hours before testing.

Click here to watch a step by step video of how to make a solvent weld joint.

Solvent weld joints are permanent - they cannot be demounted once the joint has been made. When using solvent cement, always work in a well ventilated area and keep the cement away from heat sources or naked flames. Avoid any contact with skin - if contact does occur then wash thoroughly with soap and water.

YOU MAY ALSO LIKE